The parameter s will automatically be shown on the screen. This error may have been caused by a weak battery. Format the diskette and try again. Swap Floppy Drive When this option is enabled and the system is booting from the floppy drive, the system will boot from drive B instead of drive A. Your LAN card must support the remote wakeup function. There is not enough space left on the diskette. Set JP2 pins 2 and 3 to On.

Uploader: Nikozil
Date Added: 16 January 2004
File Size: 53.31 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 89723
Price: Free* [*Free Regsitration Required]

The system will reboot and you will once again see the initial diagnostics on the screen. This utility is included in the CD that came with the system board. The default settings will be loaded.

Green Switch This switch will allow your system to enter the Suspend mode. Enter Setup to correct the error.


The utility can also ca35-d/l/s configured so that cw53-d/l/s beeping alarm will sound whenever an error occurs. To install the driver, please follow Windows VGA installation procedures. There is not enough space left on the diskette. You are limited to eight characters. The user will assume the entire risk of the use or the results of the use of this document.


Enable default 20 1 1 2 2 3 3 On: Failure to do so may damage the system board. Page 19 Hardware Installation 2. When enabled, a warning message will appear when the chassis is open.

In a few cases, drives from two different manufacturers will not function properly when used together. Typematic Rate Setting When disabled, continually holding down a key on your keyboard will cause the BIOS to report that the key is down. The cw3-5d/l/s of the pin functions on some IrDA cable may be reversed from the pin function defined on the system board.

Move away any objects, such as another monitor or fan, that may be creating a magnetic field around the display. It will then recreate a new set of configuration data. If you have changed the color or resolution in the Display Properties dialog boxdo not apply the settings without restarting. In the vw35-d/l/s CMOS setup, you have to use the scroll bar to view the fields.

Dif Values Normal F6: Paging Mode Control This field is used to select the paging mode control. Hard Disk s fail 80 HDD reset failed. Month displays the month, from January to December.

DFI CW35 Series User Manual

Some monitors have a switch that chooses between analog and TTL or digital operation. Some of the most common things to check when you encounter problems while using your system are listed below. Click Apply, then click OK.


Reset Switch This switch allows you to reboot without having to fw35-d/l/s off the system thus prolonging the life of the power supply or system. Connect a stereo cable from the line-out jack of your external device to this line-in jack. Day displays a day, from Sunday to Saturday. You must have two floppy drives to use this function.

Power up in column mode.

User`s manual | DFI CW35-S Motherboard

The commands at the bottom of the screen will allow you to navigate through the various setup menus. If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the system chassis. Troubleshooting Hard Drive Hard disk failure. Make sure the correct drive type cw335-d/l/s the hard disk drive has been entered in the BIOS.

Author: admin